![]() ![]() If you smell gas while lighting the water heater, turn off the heater immediately. Finally, set the thermostat knob to your desired temperature setting.Release the combination gas control knob and put the outer door back on.For lighting a new water heater, the pilot light should come on within two-three attempts. If the status light doesn’t start blinking after 90 seconds, follow the steps from 1-4 again to light the pilot light.You may need to dim your room lights to see the pilot light. Once the status light begins to blink, verify the pilot is lit by viewing the pilot flame through the sight glass window.Do this several times until the status light starts blinking. Now, depress and hold the thermostat or gas control knob all the way in and keep depressing the piezo-electric spark generator button (Igniter) at the same time. ![]() Rotate the thermostat knob clockwise to the Pilot position.It’s just below the thermostat control knob. Take off the outer door and locate the piezo-electric spark generator button.Wait five minutes to let all the gas clear out.Set the combination gas control knob to the Off position by rotating it counter-clockwise.Otherwise, you can’t run the water heater to heat water for the shower.įollow the below step-by-step instructions to light the pilot light on your Rheem Water Heater: For proper operation, it’s indispensable to light the pilot correctly. Your Rheem Water Heater status light won’t blink if you fail to light the pilot. Once you successfully light the pilot, set the gas combination control knob to your desired setting. In the next chapter, I will let you know how to light the pilot light on the Rheem water heater. If you turn on the heater for the first time, you should first turn on the pilot light. Just turn the combination gas control to the on position. As a result, the status light will also not gleam as you can’t light the water heater without gas. When the combination gas control will remain in off position, no fuel will go to the combustion chamber. Without fuel, it’s impossible to turn on the water heater. Rheem Water Heater Light is not blinking because of the turned off combination gas control, pilot is not lit, and insufficient power supply.īesides, igniter wires issues and a faulty or tripped thermal switch are other two culprits that prevent the status light from flickering.īelow, I will describe each of those issues and provide the potential solutions to them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |